GMP J2 Cable Lasher w/ Hard Carrying Case

The J2 Lasher from GMP can lash single or multiple aerial cable bundles up to 3 inches in diameter on a suspension strand of 1/4 inch to 7/16 inches. The J2 has an all-range tensioning device to optimize strand traction and high strength front and rear gates for tighter cable lashing. The J2 features a built-in mechanical brake to prevent unintended reversal and an automatic drum lock for easy span transfer.

Features:

• Consists of a rotating drum supported on a carriage that provides the mounting for a driving mechanism, cable lifters, cable and strand rollers
• Fast setup procedure, quick coil loading, and automatic drum lock for easy span transfers and smooth forward travel
• J2 Lashers make overlashing easy. Just push down on the strand roller knob, rotate it a quarter turn and you can lash additional cables together on previously lashed cable
• Positive internal gear to gear mechanism has no chains or belts to stretch, slip or break
• Constructed with heat-treated, plated steel, stainless steel, brass and aluminum components. Contains sealed and oiless bearings to minimize maintenance and assure durability
• Pre-drilled and tapped at the factory for mounting of the lasher guard or “halo”. For use when lashing in overgrown areas.
• The J2 and every GMP lasher is fully serviceable to “good-as-new” specifications at our factory and at factory-trained service locations around the globe
• The lasher is furnished with a rugged lightweight storage chest with corrosion resistant hardware, recessed latches and a moisture-proof, tongue-in-groove design for maximum protection when not in use
• Supplied with a 6 ft. bridle rope assembly and snap hooks, and an information and operation manual

Specifications:

• Will lash any single or multiple aerial cables up to 3 in. (76 mm) diameter across on any suspension strand from 1/4 in. (6 mm) to 7/16 in. (11 mm). A factory modification will allow the lasher to accommodate 1/2 in. (12.7 mm) strand if necessary
• Each of two recessed magazines will hold a 1200 ft. coil of .045 in. (365 m of 1.1 mm wire) lashing wire (or 450 ft. of .065 in.). The Lashing Wire is fully recessed and covered by a gate

Kit Includes:

• 1x J2 Lasher
• 1x Rope with Hooks
• 1x Hard Carrying Case
• 1x Operation Manual